Description
Rofun 360A 36cc Orange Buggy Overview
Rofun 360A 1/5 scale 36cc gasoline buggy featuring CNC metal suspension, a metal roll cage, upgraded drivetrain components, and an LCD radio system.
Features
- 36cc single-cylinder, air-cooled, two-stroke gasoline engine
- Walbro 1107 carburetor and NGK spark plug
- CNC metal front and rear suspension
- CNC front shock tower and rear shock bracket crossbar
- 18KG all-metal-gear throttle servo
- 60KG metal-gear steering servo with plastic shell
- Dominator exhaust pipe and metal differential shell
- Metal roll cage, metal clutch tripod, and 9mm half shafts
- Front and rear anti-roll bars and 8mm metal shocks
- BER-TRC4 LCD 2.4GHz six-channel radio system
- Built-in 6V 2000mAh battery, USB charger, and emergency repair kit
Specifications
- Overall size: 817 x 480 x 255mm
- Front track width: 395mm
- Rear track width: 400mm
- Wheelbase: 570mm
- Drive system: rear-wheel drive
- Braking: rear axle
- Clutch: 8000 RPM
- Approximate radio range: 150 meters
- Transmitter requires four AA batteries, not included
- Forward and left/right control; reverse requires a separately installed reverse unit
Assembly and Operation
Install the wheels, charge the vehicle battery for at least two hours, and install four AA batteries in the transmitter before operation. The included USB charger connects to the vehicle charging plug without battery removal. Allow the battery to cool for 30 minutes after charging and disconnect the charger within 30 minutes after the green full-charge indicator appears.
Mix gasoline and non-synthetic mineral-based two-cycle oil at a 25:1 ratio. Turn the transmitter on before powering the vehicle. The six-channel radio uses steering and throttle/brake controls for normal vehicle operation.
Starting Instructions
- Turn on the transmitter, then power on the vehicle and confirm steering and throttle response.
- Move the red choke lever to the vertical closed position.
- Press the carburetor primer bulb three or four times, or until fuel becomes visible.
- Pull the starter gently until it engages, then use short, quick pulls without extending the rope completely.
- After the engine fires, open the choke and pull one or two more times to start.
Break-In Process
Run the first cycle at idle to one-quarter throttle for about five minutes, then allow the engine to cool completely. Run the second cycle for about ten minutes at similar throttle and cool it again. During later cycles, gradually increase throttle while limiting each run to about eight to ten minutes. After approximately five heat cycles, the vehicle may be operated through a full tank at full throttle.
After break-in, tighten the exhaust pipe and inspect bolts throughout the vehicle. Clean clutch and brake assembly fasteners before applying threadlocker. Check fasteners before every run.
Failsafe protection: Always turn on the transmitter before the vehicle and turn off the vehicle before the transmitter. Leaving the receiver powered without a transmitter signal activates the braking failsafe and can overheat the throttle/brake servo.
Disclaimer and Safety Notice
All items offered by 5TRC are brand new. These hobby products may be modified or customized by their owners and are sold without warranty, express or implied. Gasoline RC vehicles can cause severe burns from hot exhaust components and serious injury from impact. Operate responsibly, keep bystanders and pets away, and inspect the vehicle before every use. By purchasing this product, you agree to hold harmless 5TRC from liability for accidents, injuries, or damages resulting from its use or misuse.
Product images may not accurately represent the actual color due to lighting, screen settings, and normal manufacturing variations.
Some of our items may include links to products on Amazon. As an Amazon Associate, I earn from qualifying purchases.
Questions? TextMail: 937-625-0005
5TRC.com, USA’s #1 Rofun Distributor
-Rofun 360A 36cc Orange Buggy-
