Rovan 5B Yellow #45 1/5 Scale RTR Gas RC Buggy, 29cc 2-Stroke, Dominator Pipe, Metal Gears

Description

• Power & Drivetrain

  • 29cc single-cylinder, air-cooled, 2-stroke gasoline engine

  • Four-point fixed engine mount

  • Rear-wheel drive

  • Rear axle brake

  • 8000 RPM clutch

  • Metal differential

  • Dominator performance exhaust

  ---

  Chassis & Suspension

  • Second-generation reinforced front and rear suspension

  • 0.24″ plastic shock absorbers (impact-tolerant)

  • Second-generation wasteland tires with updated wheels

  • High-strength ABS components for crash resilience

  ---

  Electronics

  • 15KG full metal gear throttle/brake servo

  • 60KG metal gear steering servo

  • 6V SC 2000 mAh receiver battery

  • Non-LCD 2.4GHz 6-channel RC-X6 radio

    • Channels used: steering and throttle/brake

    • Trim controls under rear cover

      • Steering trim

      • Throttle/brake trim

      • Steering travel

      • Throttle travel

  ---

  Dimensions & Weight

  • Body (L × W × H): 32.17″ × 18.90″ × 10.04″

  • Wheelbase: 22.44″

  • Track width: 15.55″ front / 15.75″ rear

  • Net weight: 26.46 lbs

  • Gross weight: 35.27 lbs

  • Packing size: 33.46″ × 18.50″ × 11.42″

  ---

  Assembly & Operation

  • Out of the Box: Ready to race once wheels are installed and battery is charged

  • Minimum 2-hour battery charge recommended

  Battery Charging

  • Built-in charge port, no disassembly required

  • USB charger included

  • Let battery cool 30 minutes after full charge

  • Remove charger within 30 minutes of green light

  • Store battery fully charged

  • Countdown timers recommended for battery longevity

  ---

  Fuel & Oil

  • Fuel ratio: 25:1 gasoline to oil (151.4 ml per gallon)

  • Use non-synthetic / mineral-based 2-cycle oil only

  • Recommended: Evinrude Johnson Premium TC-W3 Mineral 2-Cycle Oil

  • Reduces carbon buildup and plug fouling

  • Other mineral oils acceptable

  ---

  Starting Instructions

  1. Power on car and radio

  2. Set choke to closed (red lever vertical)

  3. Prime carb 3–4 times or until fuel is visible

  4. Pull starter gently until engaged, then short quick pulls

  5. Engine should fire in 1–3 pulls

  6. Open choke and pull 1–2 more times to start

  ---

  Break-In Procedure

  • Run 1: Idle to 1/4 throttle, 5 minutes, full cool-down

  • Run 2: Same, 10 minutes, full cool-down

  • Run 3: Moderate throttle, 8–10 minutes, cool-down

  • Next Runs: Total of ~5 heat cycles

  • Final: Full throttle, burn a full tank

  • After break-in, re-snug exhaust bolts

  ---

  Maintenance Notes

  • Check all bolts before each run

  • Use thread-locker on clutch and brake assemblies

  • Clean threads with alcohol before applying thread-locker

  ---

  Material Reality Check

  Aluminum upgrades look good but fail hard. They bend, crack, and transfer damage downstream. The factory high-strength ABS plastics flex, absorb impact, and survive crashes better. Many stock plastic parts are the smarter choice.

  ---

  Disclaimer & Safety Notice

  All items sold by 5TRC are brand new. No express or implied warranty. Gas RC vehicles are hobby-grade machines intended for experienced users. Exhaust components can cause severe burns. Improper use can result in serious injury or death to operators, bystanders, or pets. By purchasing, the buyer assumes all responsibility and agrees to hold 5TRC harmless from all liability arising from use or misuse.